Whirlpool appliance error codes

Whirlpool Dryer

1 guide

Whirlpool Microwave

2 guides

Whirlpool Oven / Range

2 guides

Whirlpool Washer

10 guides

Diagnostic search

Find the exact guide you need

Search by brand, appliance, error code, symptom, likely cause, or replacement part.

20 guides found

Code F6E1

F6E1 indicates a user-interface or main-control communication fault.

Code F7E2

F7E2 indicates a wash-motor fault.

Code F8E4

F8E4 indicates that water has been detected in the dishwasher drip tray.

Code F9E1

F9E1 indicates that the dishwasher is taking too long to drain or is not draining.

Code H2O

H2O indicates that the dishwasher is not detecting incoming water.

WhirlpoolDryer

Code E1 F3

E1 F3 error indicates an open electrical circuit in the dryer thermistor temperature sensor.

WhirlpoolMicrowave

Code F1

F1 code triggers when the main electronic control unit detects internal hardware memory corruption.

WhirlpoolMicrowave

Code F2

F2 indicates a button on the glass panel or membrane switch is stuck in a closed state continuously.

WhirlpoolOven / Range

Code F3 E0

F3 E0 signals that the main control unit detects an open sensor circuit in the oven temperature probe circuit.

WhirlpoolOven / Range

Code F5 E0

F5 E0 code occurs when the main control board senses door switch state does not match door lock state.

Code dET

dET appears on select models when the detergent cartridge is not detected in the dispenser.

Code F0E5

F0E5 code indicates an off-balance wash load prevented the unit from reaching full spin speed.

Code F1E1

Whirlpool washer code F1E1 signals a critical primary hardware failure on the main electronic control unit (CCU).

Code F5E2

Whirlpool washer code F5E2 indicates the main control board detects the door switch or lid lock assembly is not locking correctly.

Code F7E1

F7E1 indicates that the motor cannot achieve the expected speed for the selected cycle.

Code F8E1

F8E1 (LF) triggers when the washer fails to fill with water within the expected time limit.

Code Int

Int indicates that the washer is still finishing a paused or canceled cycle, including stopping and draining.