Quick diagnosis
What this code is telling you
Most likely trigger
cycle paused or canceled
Recommended replacement
No Replacement Part Normally Required
Diagnostic path
3 ordered checks
Part fit
Exact model number required
Safety first
Before opening the appliance
Disconnect electrical power before removing panels or handling internal components. Do not bypass safety devices or perform live electrical testing unless you are qualified to do so.
Read the full safety disclaimerRoot cause
Why the control reported this error
Int indicates that the washer is still finishing a paused or canceled cycle, including stopping and draining because cycle paused or canceled. washer still draining after cancellation and temporary control state can produce the same code, so verify the fault before replacing components.
Possible causes
Check the most likely causes first
- 1
cycle paused or canceled
Start here when it matches your symptoms.
- 2
washer still draining after cancellation
- 3
temporary control state
Diagnostic sequence
Work through these checks in order
Stop when you find the fault. Do not perform a step that requires skills or live testing you are not qualified to do.
- 1
Check 1
Allow up to 20 to 30 minutes for the washer to stop spinning and drain.
- 2
Check 2
Press Pause/Cancel twice and Power once if needed.
- 3
Check 3
If Int remains, disconnect power for 5 minutes and restore it.
Recommended next step
Troubleshoot before buying a part
This code does not point to a replacement part as the first action.
Follow the diagnostic sequence above first. Supply problems, maintenance conditions, settings, airflow restrictions, or temporary control states can often trigger this code without a failed component.
If the code returns after the listed checks, use the complete model number and manufacturer documentation before ordering anything.
Common questions
Quick answers for this fault
What should I check first for Int?
Start with cycle paused or canceled. If that checks out, continue through the diagnostic sequence above rather than replacing a part based on the code alone.
Do I need to buy a part for Int?
Usually not as the first step. This code is commonly tied to a setting, supply issue, maintenance condition, airflow restriction, or temporary operating state. Complete the diagnostic checks before considering parts.
When should I stop troubleshooting Int myself?
Stop if the next step requires live electrical testing, sealed-system work, gas or combustion service, or any procedure outside your training. Disconnect electrical power before removing panels or handling internal components. Do not bypass safety devices or perform live electrical testing unless you are qualified to do so.
Manufacturer reference
Verify against the official support source
FixCodeDB summarizes the fault in plain language. For model-specific instructions, confirm the guidance with the manufacturer and your appliance manual.
Whirlpool Front Load Washer Error Codes — Whirlpool Product Help →Was this useful?
Did these checks help with your Whirlpool Int error?
Keep diagnosing
Related Whirlpool guides
dET appears on select models when the detergent cartridge is not detected in the dispenser.
F0E5 code indicates an off-balance wash load prevented the unit from reaching full spin speed.
Whirlpool washer code F1E1 signals a critical primary hardware failure on the main electronic control unit (CCU).
Whirlpool washer code F5E2 indicates the main control board detects the door switch or lid lock assembly is not locking correctly.
Different problem?
Search another code or symptom
Go back to the main diagnostic search and try the code, symptom, appliance, component, or brand.
Open diagnostic search →