Samsung Refrigerator 33E Error Code: Causes & Fixes

Quick diagnosis

What this code is telling you

Most likely trigger

Blown ice pipe heater circuit

Recommended replacement

Ice Room Water Pipe Heater Assembly

Diagnostic path

4 ordered checks

Part fit

Exact model number required

Safety first

Before opening the appliance

Unplug the appliance before removing panels or testing internal components. Do not bypass safety switches or live-test high-voltage, gas, refrigerant, or combustion components unless you are qualified to do so.

Read the full safety disclaimer

Root cause

Why the control reported this error

The refrigerator stores this fault when a monitored cooling, fan, sensor, defrost, or power condition falls outside its expected range. Begin with blown ice pipe heater circuit; ice room door seal leak admitting moist air and damaged wiring harness are additional causes to verify before replacing ice Room Water Pipe Heater Assembly.

Symptoms

What you may notice

✓Ice maker stops making ice
✓Water fill pipe behind ice room frozen solid
✓33E code displays

Possible causes

Check the most likely causes first

1
Blown ice pipe heater circuit
Start here when it matches your symptoms.
2
Ice room door seal leak admitting moist air
3
Damaged wiring harness

Diagnostic sequence

Work through these checks in order

Stop when you find the fault. Do not perform a step that requires skills or live testing you are not qualified to do.

1
Check 1
Thaw frozen water supply line entering ice room using warm air or manual defrost.
2
Check 2
Inspect ice room gaskets for tears allowing warm air intrusion.
3
Check 3
Disconnect electrical power before opening panels. Measure resistance of ice pipe heater circuit with multimeter.
4
Check 4
Replace ice fill tube heater line or ice maker assembly.

Replacement part reference

Ice Room Water Pipe Heater Assembly

Exact OEM part number

Model number required

Fitment note

The exact OEM part number varies by model and production revision. Verify the complete model number before ordering.

Verify the appliance model before ordering.

Manufacturers can use different parts under the same error code across model families and production revisions.

Where do I find my model number? →

Search this replacement part on eBay →

FixCodeDB may earn a commission from qualifying purchases made through affiliate links.

Common questions

Quick answers for this fault

What should I check first for 33E?

Start with blown ice pipe heater circuit. If that checks out, continue through the diagnostic sequence above rather than replacing a part based on the code alone.

Does 33E always mean Ice Room Water Pipe Heater Assembly is bad?

No. An error code identifies the condition the control detected, not a guaranteed failed part. Confirm the likely causes and wiring first. The exact OEM part number varies by model and production revision. Verify the complete model number before ordering.

When should I stop troubleshooting 33E myself?

Stop if the next step requires live electrical testing, sealed-system work, gas or combustion service, or any procedure outside your training. Unplug the appliance before removing panels or testing internal components. Do not bypass safety switches or live-test high-voltage, gas, refrigerant, or combustion components unless you are qualified to do so.

Manufacturer reference

Verify against the official support source

FixCodeDB summarizes the fault in plain language. For model-specific instructions, confirm the guidance with the manufacturer and your appliance manual.

Samsung Refrigerator Error Codes — Samsung Support →

Was this useful?