Brand diagnostic hub
GE appliance error codes
Search 18 GE diagnostic guides across 5 appliance types. Start with the appliance category or search the code or symptom directly.
Diagnostic search
Find the exact guide you need
Search by brand, appliance, error code, symptom, likely cause, or replacement part.
18 guides found
Code E01 / P1
E01 appears on certain 70-pint models with a built-in drain pump when Pump Out mode is selected but water is not being pumped out.
Code H2O
H2O code indicates insufficient water entered the dishwasher sump during the wash fill cycle.
Code F3
F3 indicates the main control board senses a stuck or shorted touch key switch on the membrane.
Code SENSOR ERROR
SENSOR ERROR occurs when the humidity/steam sensor fails to send valid voltage signals during Sensor Cook mode.
Code Bad Line
Bad Line appears when the range or oven detects incorrect electrical wiring at the power connection.
Code F0 / F1 / F6 / F7
GE documents F0, F1, F6, and F7 as keypanel-related faults on applicable ranges and wall ovens.
Code F2 / F20
F2 or F20 indicates that oven temperature exceeded a preset safety threshold.
Code F3 / F4
GE documents F3 and F4 as oven-temperature-sensor faults on applicable ranges and wall ovens.
Code F30
Code F30 indicates the electronic control board senses an open circuit (infinite resistance) in the oven sensor circuit.
Code F350
F350 indicates a problem in the upper cooling-fan circuit or an obstruction affecting that fan.
Code F5
GE says F5 usually indicates an electronic-control problem.
Code F8 / FF
GE documents F8 and FF as electronic-control faults on applicable ranges and wall ovens.
Code F9
GE says F9 usually indicates a failure somewhere in the oven door-lock circuit.
Code F90
F90 indicates the electronic control failed to verify the door lock mechanism position during self-clean cycle.
Code FC
GE says FC usually indicates a failure somewhere in the door-lock circuit.
Code FD
FD usually means the temperature probe or its receptacle may require service.
Code E22
GE washer E22 code indicates water fill rate was too slow or failed to reach level sensor target in allotted time.
Code E30
E30 code indicates GE washer failed to drain water completely within the pre-set drain window.