Quick diagnosis
What this code is telling you
Most likely trigger
damaged meat probe
Recommended replacement
Oven Meat Probe / Receptacle
Diagnostic path
3 ordered checks
Part fit
Exact model number required
Safety first
Before opening the appliance
Turn the appliance off before internal service. Cooking appliances can contain 120/240-volt circuits, high-temperature surfaces, and on gas models combustible fuel; qualified service is recommended for internal electrical or gas work.
Read the full safety disclaimerRoot cause
Why the control reported this error
FD usually means the temperature probe or its receptacle may require service because damaged meat probe. probe receptacle fault and probe circuit connection problem can produce the same code, so verify the fault before replacing components.
Possible causes
Check the most likely causes first
- 1
damaged meat probe
Start here when it matches your symptoms.
- 2
probe receptacle fault
- 3
probe circuit connection problem
Diagnostic sequence
Work through these checks in order
Stop when you find the fault. Do not perform a step that requires skills or live testing you are not qualified to do.
- 1
Check 1
Turn the oven or range off and record the code.
- 2
Check 2
Disconnect power for at least 60 seconds, then restore power once.
- 3
Check 3
If the code returns, stop repeated resets and diagnose the listed circuit using the model service information.
Replacement part reference
Oven Meat Probe / Receptacle
Exact OEM part number
Model number required
Fitment note
The exact OEM part number varies by model and production revision. Verify the complete model number before ordering.
Verify the appliance model before ordering.
Manufacturers can use different parts under the same error code across model families and production revisions.
Where do I find my model number? →FixCodeDB may earn a commission from qualifying purchases made through affiliate links.
Common questions
Quick answers for this fault
What should I check first for FD?
Start with damaged meat probe. If that checks out, continue through the diagnostic sequence above rather than replacing a part based on the code alone.
Does FD always mean Oven Meat Probe / Receptacle is bad?
No. An error code identifies the condition the control detected, not a guaranteed failed part. Confirm the likely causes and wiring first. The exact OEM part number varies by model and production revision. Verify the complete model number before ordering.
When should I stop troubleshooting FD myself?
Stop if the next step requires live electrical testing, sealed-system work, gas or combustion service, or any procedure outside your training. Turn the appliance off before internal service. Cooking appliances can contain 120/240-volt circuits, high-temperature surfaces, and on gas models combustible fuel; qualified service is recommended for internal electrical or gas work.
Manufacturer reference
Verify against the official support source
FixCodeDB summarizes the fault in plain language. For model-specific instructions, confirm the guidance with the manufacturer and your appliance manual.
GE Range & Wall Oven Fault Codes — GE Appliances →Was this useful?
Did these checks help with your GE FD error?
Keep diagnosing
Related GE guides
Bad Line appears when the range or oven detects incorrect electrical wiring at the power connection.
GE documents F0, F1, F6, and F7 as keypanel-related faults on applicable ranges and wall ovens.
F2 or F20 indicates that oven temperature exceeded a preset safety threshold.
GE documents F3 and F4 as oven-temperature-sensor faults on applicable ranges and wall ovens.
Different problem?
Search another code or symptom
Go back to the main diagnostic search and try the code, symptom, appliance, component, or brand.
Open diagnostic search →