Quick diagnosis
What this code is telling you
Most likely trigger
clogged drain pump filter
Recommended replacement
Drain Pump
Diagnostic path
3 ordered checks
Part fit
Exact model number required
Safety first
Before opening the appliance
Disconnect electrical power before removing panels or handling internal components. Do not bypass safety devices or perform live electrical testing unless you are qualified to do so.
Read the full safety disclaimerRoot cause
Why the control reported this error
The unit is not draining water normally because clogged drain pump filter. kinked or over-inserted drain hose and drain pump fault can produce the same code, so verify the fault before replacing components.
Possible causes
Check the most likely causes first
- 1
clogged drain pump filter
Start here when it matches your symptoms.
- 2
kinked or over-inserted drain hose
- 3
drain pump fault
Diagnostic sequence
Work through these checks in order
Stop when you find the fault. Do not perform a step that requires skills or live testing you are not qualified to do.
- 1
Check 1
Clean the drain-pump filter at the lower service door.
- 2
Check 2
Check the drain hose for kinks and correct standpipe insertion.
- 3
Check 3
If Err2 remains, service the drain system.
Replacement part reference
Drain Pump
Exact OEM part number
Model number required
Fitment note
The exact OEM part number varies by model and production revision. Verify the complete model number before ordering.
Verify the appliance model before ordering.
Manufacturers can use different parts under the same error code across model families and production revisions.
Where do I find my model number? →FixCodeDB may earn a commission from qualifying purchases made through affiliate links.
Common questions
Quick answers for this fault
What should I check first for Err2?
Start with clogged drain pump filter. If that checks out, continue through the diagnostic sequence above rather than replacing a part based on the code alone.
Does Err2 always mean Drain Pump is bad?
No. An error code identifies the condition the control detected, not a guaranteed failed part. Confirm the likely causes and wiring first. The exact OEM part number varies by model and production revision. Verify the complete model number before ordering.
When should I stop troubleshooting Err2 myself?
Stop if the next step requires live electrical testing, sealed-system work, gas or combustion service, or any procedure outside your training. Disconnect electrical power before removing panels or handling internal components. Do not bypass safety devices or perform live electrical testing unless you are qualified to do so.
Manufacturer reference
Verify against the official support source
FixCodeDB summarizes the fault in plain language. For model-specific instructions, confirm the guidance with the manufacturer and your appliance manual.
Haier Combination Washer/Dryer Error Codes — Haier Appliances →Was this useful?
Did these checks help with your Haier Err2 error?
Keep diagnosing
Related Haier guides
The washer cannot drain the water within the expected time.
Haier associates E13 with lint buildup in the combination washer/dryer.
The unit cannot lock the door within the expected time.
The selected water level was not reached within the expected time.
Different problem?
Search another code or symptom
Go back to the main diagnostic search and try the code, symptom, appliance, component, or brand.
Open diagnostic search →