Quick diagnosis
What this code is telling you
Most likely trigger
Restricted supply taps
Recommended replacement
Water Inlet Valve
Diagnostic path
4 ordered checks
Part fit
Exact model number required
Safety first
Before opening the appliance
Unplug the appliance before removing panels or testing internal components. Do not bypass safety switches or live-test high-voltage, gas, refrigerant, or combustion components unless you are qualified to do so.
Read the full safety disclaimerRoot cause
Why the control reported this error
The washer sets this code when its control cannot confirm the expected wash-cycle condition. Start by ruling out restricted supply taps. clogged inlet screens and faulty water valve can create the same feedback, so confirm the failure before replacing water Inlet Valve.
Symptoms
What you may notice
- ✓Washer taking excessive time to fill
- ✓E11 error code displays
- ✓Cycle halts mid-fill
Possible causes
Check the most likely causes first
- 1
Restricted supply taps
Start here when it matches your symptoms.
- 2
Clogged inlet screens
- 3
Faulty water valve
- 4
Leaking pressure hose
Diagnostic sequence
Work through these checks in order
Stop when you find the fault. Do not perform a step that requires skills or live testing you are not qualified to do.
- 1
Check 1
Verify home water supply valves are open completely.
- 2
Check 2
Clean inlet screen filters on rear water connections.
- 3
Check 3
Disconnect electrical power before opening panels. Check water valve solenoids for proper resistance.
- 4
Check 4
Replace water inlet valve if water flow remains poor.
Replacement part reference
Water Inlet Valve
Exact OEM part number
Model number required
Fitment note
The exact OEM part number varies by model and production revision. Verify the complete model number before ordering.
Verify the appliance model before ordering.
Manufacturers can use different parts under the same error code across model families and production revisions.
Where do I find my model number? →FixCodeDB may earn a commission from qualifying purchases made through affiliate links.
Common questions
Quick answers for this fault
What should I check first for E11?
Start with restricted supply taps. If that checks out, continue through the diagnostic sequence above rather than replacing a part based on the code alone.
Does E11 always mean Water Inlet Valve is bad?
No. An error code identifies the condition the control detected, not a guaranteed failed part. Confirm the likely causes and wiring first. The exact OEM part number varies by model and production revision. Verify the complete model number before ordering.
When should I stop troubleshooting E11 myself?
Stop if the next step requires live electrical testing, sealed-system work, gas or combustion service, or any procedure outside your training. Unplug the appliance before removing panels or testing internal components. Do not bypass safety switches or live-test high-voltage, gas, refrigerant, or combustion components unless you are qualified to do so.
Was this useful?
Did these checks help with your Frigidaire E11 error?
Keep diagnosing
Related Frigidaire guides
E20 or E21 indicates the washer is taking too long to pump water out of the machine.
F08 alerts that communication between the user interface panel board and main power logic board has failed.
F10 triggers when a key input is detected as active continuously for longer than 60 seconds.
F10 indicates the control board senses oven temperature rising above safe limits or heating uncontrollably.
Different problem?
Search another code or symptom
Go back to the main diagnostic search and try the code, symptom, appliance, component, or brand.
Open diagnostic search →